Skip to main content

JBUS Tracker Installation Guide

Step-by-step instructions for installing and activating a JBUS GPS tracker in your vehicle, including hardware setup and the text-to-activate process.

📝 Note: Your tracker arrives pre-activated, tested, and associated with your account. The steps below add your vehicle's information through the text-to-activate process. For the best results, complete installation with the vehicle parked outside to ensure a strong GPS and cellular connection.

If your tracker already has a name assigned in Vehicle Admin: Complete steps 1–3, wait 5 minutes, then skip to steps 8–9. Confirm the vehicle appears on the map, then fill in any remaining details in the Vehicle Admin page.

Installation Steps

  1. Replace the JBUS port. Remove the stock port from your vehicle by unscrewing its four screws, then screw in the replacement port provided.
    ​

  2. Connect the new cable to the stock port. Plug the male end of the new JBUS cable into the old stock port that is now hanging free.

  3. Plug in the tracker. Connect the GPS tracker to the cable rig. You should see flashing lights as it boots up. No lights indicates no power — resolve this before continuing.

  4. Record the Activation Code. Locate the 15-digit number on the white label. Take a photo or write it down. This code is also listed as the "Unique ID" in your Vehicle Admin page.

  5. Wait 5 minutes. The device needs time to boot and establish cellular and satellite connections. Use this time to tuck and secure the cables out of the way.

  6. Text the Activation Code to ClearPathGPS at (805) 695-2388.

  7. Respond to the setup prompts. You'll receive a series of texts asking for the following vehicle details:

    • Vehicle Name (as it will appear on the map)

    • VIN (found on the registration or the vehicle itself)

    • License Plate

    • Current Odometer

  8. Turn on the engine and wait 30 seconds.

  9. Turn off the engine and wait 30 seconds.

  10. Text "done". You should receive a confirmation text saying "installation complete."

Troubleshooting Tips

  • Vehicle details can be reviewed and edited anytime in the Vehicle Admin page.

  • If you receive an IgnOn(Fail) error: Start the engine, wait 30 seconds, turn it off, wait 30 seconds, then text DONE to re-test ignition detection.

  • If you get stuck: Text RESET to start over with the current vehicle. You can only activate one vehicle at a time.

  • Need help? Call ClearPathGPS Support at (805) 979-3442.

Device activation does not affect billing. Subscriptions activate based on your agreed terms.

Related Articles
Did this answer your question?